Disconnect Remote Or Lan Console; Mp Firmware Update; Help; Display System Id - HP Integrity rx1600 Operation And Maintenance Manual

Utilities
Management Processor Command Interface
This command displays FRUID information from the BMC for FRU devices. Information provided includes serial number;
part number; model designation; name and version number; and manufacturer.

Disconnect Remote or LAN Console

DI: DIsconnect remote/modem or LAN/WEB console
This command disconnects (hang up) the remote/modem or LAN/WEB users from MP. It does not disable the ports. The
remote console is no longer mirrored.

MP Firmware Update

FW: Activates MP firmware upgrade mode
This command is available from either the LAN or local serial port. This command activates firmware upgrade mode, which
loads new firmware through the MP LAN by FTP (which must be operational). An MP Reset is generated after the upgrade is
complete.

Help

HE: Display help for menu or command
This command displays the MP hardware and firmware version identity, and the date and time of firmware generation. If
executed from the MP Main Menu, general information about the MP, and those commands displayed in the MP Main Menu,
will be displayed. If executed in command mode, this command displays a list of command interface commands available to
the user. It also displays detailed help information in response to a topic or command at the help prompt.

Display System ID

ID: Display/modify system information
This command allows the user to display and modify the following:
• SNMP contact information
• SNMP server information
• SPU hostname

Inactivity Timeout

IT: Inactivity Timeout settings
The session inactivity timeout is up to 1,440 minutes—default is 60 minutes. This timeout prevents sessions to the system
from being inadvertently left open. A session can be started by the SE command. An open session can prevent users from
logging onto the MP through a port and can also prevent system applications from initiating an outbound connection.
MP inactivity timeout is up to 1,440 minutes—default is 5minutes. This timeout prevents a user from inadvertently keeping
the MP locked in a MP Command Interface mode preventing other users from looking at the console output. The MP
Command Interface inactivity. timeout may not be deactivated.
Flow control timeout is 0 to 60 minutes. If set to 0, no timeout is applied. This timeout prevents mirrored flow control from
blocking other ports when inactive.

Configure LAN Console

LC: LAN configuration (IP address, and so on)
88
Chapter 5