Removing and Replacing Components
Removing and Replacing PCI Cards
CAUTION
Record the location of all PCI cards as they are installed. Depending on the operating system, replacing the
PCI card in a different location might cause boot failure.
Step
1. Remove the cover. See "Removing and Replacing the Cover".
Step
2. Disconnect any cables that are connected to the PCI card.
Step
3. Release the PCI I/O riser by turning the jackscrew. This action frees the PCI I/O riser from the system board.
Figure 7-30Using Jackscrew to Release PCI I/O Riser
Step
4. Grasp the edges of the PCI card being removed and gently rock the card releasing the connector from the PCI I/O
riser connector. Place the removed PCI card in an antistatic container.
Step
5. Install a PCI slot cover to close the cavity left by the removal of the PCI card. This will maintain the proper airflow
within the chassis.
Step
6. Replace the PCI I/O riser assembly by positioning the connector over the mating connector on the system board
and then turning the jackscrew to complete the connector mating.
158
Chapter 7