Removing and Replacing Components
Removing and Replacing System Memory
Step
2. Close the cover by moving the latch handle clockwise.
Figure 7-4Closing the Cover
Removing and Replacing System Memory
System memory DIMMs are located on the system board.
WARNING
Ensure that the system is powered-down and all power sources have been disconnected from the server
prior to removing or replacing system memory.
Voltages are present at various locations within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
136
OPEN
CLOSED
Chapter 7