Removing And Replacing Components; Esd Information; Required Tools; Internal Component And Connector Locations - HP Integrity rx2620 User's & Service Manual

4 Removing and Replacing Components

This chapter describes the procedure for removing and replacing the different
components in the server.

ESD Information

Follow the procedures listed below to ensure safe handling of components and to
prevent harm to both you and the server:
Use an anti-static wrist strap and a grounding mat, such as those included in the
Electrically Conductive Field Service Grounding Kit (HPE 9300-1155).
Handle accessory boards and components by the edges only. Do not touch any
metal-edge connectors or any electrical components on accessory boards.
Do not wear clothing subject to static charge build-up, such as wool or synthetic
materials.

Required Tools

Service of this product might require one or more of the following tools:
IPF CPU Installation Tool Kit (P/N 5069-5441), consisting of:
Disposable ESD Kit
Label-less CPU install tool (2.5mm hex and T-15 Torx screwdrivers)
1/4 inch standard screwdriver
Phillips No. 1 Screwdriver
ACX-10 Torx screwdriver
ACX-15 Torx screwdriver
ACX-25 Torx screwdriver

Internal Component and Connector Locations

Figure 15 and Table 16 show the locations of the internal server components.
29