Removing and Replacing Components
Removing and Replacing a Processor
Step
2. Gently and evenly push on each side of the DIMM until it seats in the socket. Ensure the extraction levers are in
the closed position.
Step
3. Replace the top cover.
Figure 7-6
Inserting a DIMM into Slot
Removing and Replacing a Processor
This section provides information about removing and replacing processors.
Processors are located on the system board. The system board can support either one or two processors. CPU 0 is located to the
right of the system board and CPU 1 (when installed) is located on the left of the system board next to the bridge assembly. In
a single CPU configuration, the single processor must be installed in CPU 0 slot.
138
Chapter 7