System Information
System Board
•
Scratch RAM
•
Real Time Clock
•
UARTs
•
External Registers
•
Firmware read/writable registers
•
Two general purpose 32-bit registers
•
Semaphore registers
•
Monarch selection registers
•
Test and Reset register
•
Reset and INIT generation
Dual Serial Controller
The dual serial controller is a dual universal asynchronous receiver and transmitter (DUART). This chip provides enhanced
UART functions with 16-byte FIFOs, a modem control interface. Registers on this chip provide onboard error indications and
operation status. An internal loopback capability provides onboard diagnostics.
Features include:
•
Data rates up to 115.2kbps
•
16550A fully compatible controller
•
A 16-byte transmit FIFO to reduce the bandwidth requirement of the external CPU
•
A 16-byte receive FIFO with four selectable interrupt trigger levels and error flags to reduce the bandwidth requirement of
the external CPU
•
UART control that provides independent transmit and receive
•
Modem control signals (-CTS, -RTS, -DSR, -DTR, -RI, -CD, and software controllable line break)
•
Programmable character lengths (5, 6, 7, 8) with Even, Odd or No Parity
•
A status report register
Field Programmable Gate Array
The field programmable gate array (FPGA) provides ACPI and low pin count (LPC) support for HP Intel Itanium 2 platforms
based on HP chipsets. This controller is connected to the PDH bus and provides these features:
•
ACPI 2.0 interface
•
LPC bus interface to support BMC
•
Decoding logic for PDH devices
Baseboard Management Controller
The baseboard management controller supports the industry-standard Intelligent Platform Management Interface (IPMI)
specification. This specification describes the management features that have been built into the system board. These features
include: diagnostics (both local and remote) console support, configuration management, hardware management, and
troubleshooting.
190
Appendix A