Figure 7-44Location Of Components Of Base Unit - HP Integrity rx1600 Operation And Maintenance Manual

Removing and Replacing Components
Replacing the Base Unit
• Display Panel

Figure 7-44Location of Components of Base Unit

DIMMs
Management
Processor Filler
(on rear panel)
PCI I/O Backplane
Assembly
Power Supply
Step 2. Install the previously removed components into the new base unit. Refer to earlier sections of this chapter for
component removal and replacement instructions.
• Power Supply Fans
• Power Supply
• Chassis Fans
• Management Processor card (optional card, may be present)
• Management Processor Blank (present when Management Processor not installed)
• PCI I/O Backplane Assembly
• CPU(s)
• CPU Airflow guide (single CPU systems only)
• Memory DIMMs
• DVD or CD-ROM
• DVD Filler (present when a DVD or CD-ROM is not installed)
172
Management
Processor card
CPU Power
Power Supply Fans
CPU Airflow guide
(single CPU config.)
CPU(s)
Chassis Fans
HDD filler if no HDD
DVD or
CD-RW/DVD
DCD filler if no DVD
Display Panel
Hard Disk
Drive (HDD)
Chapter 7