Removing And Replacing The Front Bezel; Removing The Front Bezel; Replacing The Front Bezel; Figure 7-1 Front Bezel - HP Integrity rx1600 Operation And Maintenance Manual

Removing and Replacing the Front Bezel

The server does not have to be turned off to remove the front bezel. The front bezel of the hp Integrity rx1600 Server consists
of a left and right bezel part. The right bezel part provides the server controls and LED access ports.
Figure 7-1 Front Bezel

Removing the Front Bezel

To remove the front bezel parts, perform the following steps:
Step 1. Remove the screw securing the right front bezel to the chassis.
Step 2. Grasp the right front bezel at the outer edge and pull straight out.
Step 3. Remove the screw securing the left front bezel to the chassis.
Step 4. Grasp the left front bezel at the outer edge and pull straight out.

Replacing the Front Bezel

To replace the front bezel parts, perform the following steps:
Step 1. Slide the right front bezel onto the tab on the chassis until it snaps into place.
Step 2. Install the screw securing the right front bezel to the chassis.
Chapter 7
Removing and Replacing Components
Removing and Replacing the Front Bezel
133