Replacing The Base Unit - HP Integrity rx1600 Operation And Maintenance Manual

CAUTION
Step 2. Perform all of the steps described in the procedure for Replacing the optional management processor card.

Replacing the Base Unit

Use this checklist to verify all parts from the original system have been moved to the base unit.
NOTE
Be sure to copy PRODUCT NUMBER, SERIAL NUMBER and UUID values onto the blank labels and apply
them to the base unit.
Step 1. Remove the following components from your existing base unit. Refer to earlier sections of this chapter for
component removal and replacement instructions.
• Power Supply Fans
• Power Supply
• Chassis Fans
• Management Processor card (optional card, may be present)
• Management Processor Blank (present when Management Processor not installed)
• PCI I/O Backplane Assembly
• CPU(s) and associated Power Pods
• CPU Airflow guide (single CPU systems only)
• Memory DIMMs
• DVD or CD-ROM
• DVD Filler (present when a DVD or CD-ROM is not installed)
• Disk(s)
• Disk Filler(s) (present on disk-less systems)
Chapter 7
Only lift the battery high enough to clear the holder. Excessive stress on the battery holder
retaining clip may damage the clip.
Removing and Replacing Components
Replacing the Base Unit
171