SATO MB200i Programming Reference Manual page 75

OFFSET
FUNCTION
Temporarily specifies the label stop position for each mode of operation.
FORMAT
<ESC>POabcc
Place after <ESC>A but before <ESC>V.
EXAMPLE
<ESC>A
<ESC>PO3+08
<ESC>Z
OUTPUT This command does not result in printer output.
NOTES
This command is not required to be specified for normal print operation.
(4-29)
"i" Programming Reference
Unit 4: Standard Command Codes
a = Offset
0: Not used
1: Dispenser mode
2: Tear-Off mode
3: Label pitch
b = Offset direction
+: Advance label feed
-: Retract label feed
c = Offset range in dots (00 to 99)
+0
TEXT
4-45
Top of Form
+8
TEXT
PN: 9001158B