SATO MB200i Programming Reference Manual page 34

JOB ID, STORE
FUNCTION
To add an identification number to a job. The status of the job can then be determined using the ENQ
command in the Bi-Com status mode.
FORMAT
<ESC>IDaa
Place immediately following the <ESC>A in the job data stream.
EXAMPLE
<ESC>A
<ESC>ID02
. . . Job . . .
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
Works only in Bi-Communications modes. To view the job ID, an ENQ command must be sent while in
Bi-Com mode.
If more than one ID number is sent in a single job, i.e.
<ESC>A
<ESC>ID01
. . . . . . . . . .
<ESC>ID02
. . . . . . . . .
The last number transmitted will be used.
"i" Programming Reference
Unit 4: Standard Command Codes
aa = Job ID assigned (01 to 99)
4-4
PN: 9001158B