SATO MB200i Programming Reference Manual page 62

EU
NOTES
The parameter feature varies depending on the 1D barcode symbology. The parameter for barcode
height is only designable for UCC/EAN-128 (EU11, EU12).
When the value in 1D barcode symbology is not set to the data portion, the composite symbol will not
be printed.
In this command, parameter for the print data can accept up to 120 digits for the sum of 1D and 2D
data. For 2D data, when 1D barcode symbology and alphnumeric are mixed, the designable data size
may vary.
The entire size of composite symbol may change depending on the specification of minimum bar width.
If the composite symbol exceeds the printable area, only the portion located within the area will be
printed, but a scanner may be able to occationally read the value.
This command does not support RSS Expand.
Print of HRI cannot be designated with this command.
Rotation (<ESC>%) is available, but Enlargement (<ESC>L) is invalid.
Example: If minimum bar width is 3 and barcode height is 100, its size = 300 dots.
To specify the print of composite symbol, delimit 1D data and 2D data with "I"(7Ch). Example: Data =
1D data/2D data. Use "#" (23h) to specify FNC1 (GS) of CC-C (for PDF417) as data.
"i" Programming Reference
Unit 4: Standard Command Codes
4-32
PN: 9001158B