SATO MB200i Programming Reference Manual page 107

IP ADDRESS SPECIFICATION
FUNCTION
Sets the IP address.
FORMAT
<ESC>W1a-a
Place after <ESC>A and before <ESC>Z.
EXAMPLE
<ESC>A
<ESC>W1128220000040
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
This command is only valid for printers conforming to WLAN specifications.
This command must be preceded by the <ESC>A command and followed by the <ESC>Z command in
a separate string and cannot be used in conjunction with other commands.
This command becomes valid upon restarting of the printer and may be confirmed by performing a test
print.
The default setting is as follows: 000.000.000.000 .
When restarting the printer after command execution, the command contents will be processed for
WLAN interface. The printer will go into sleep mode after completing the settings and the printer can
then be powered off. Do not power off theprinter until it has gone into sleep mode.
"i" Programming Reference
Unit 5: Optional Command Codes
Settings without decimals up to 12 places.
a =
5-11
PN: 9001158B