Ricoh Aficio MP 3500 Operating Instructions Manual page 170

Facsimile Features
Programming End Receivers
This section describes how to program End Receivers of Transfer Box.
A
Select an End Receiver.
Press [Receiving Stn 1-5].
You can store five Receiving Station.
B
Specify End Receivers with Destination keys, and then press [OK].
4
You can change the display to the fax destination, Internet fax destination,
and IP-Fax destination using the key on the left side of the display.
A reception station can also be registered as a group destination. In such a
case, a maximum of 500 parties including End Receiver 1-5 can be specified
in a group.
To register another End Receiver, repeat from step
Programming a password
This section describes how to program a password for the Transfer Box.
A
Press [Password].
B
Enter a password, and then press [OK].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
C
Re-enter the password, and then press [OK].
To change the password after pressing [OK], press [Change] and repeat steps
C
and , or press [Cancel] and repeat from step
162
A
.
A
.
B