Analog Signal Calibration Settings - Hitachi X200 Series Instruction Manual

Analog Signal Calibration Settings

The functions in the following table
configure the signals for the analog
input terminals.
settings do
current/voltage
characteristics – only the zero and
span (scaling) of the signals.
Func. Name /
Code SRW Display
C081 O input span calibration
O-ADJ
C082 OI input span calibration
OI-ADJ
C086 AM offset calibration
AM OFFST
NOTE: When you restore factory default settings, the values will change to those listed
above. Be sure to manually reconfigure the values for your application, if needed, after
restoring factory defaults.
Note that these
not change the
or sink/source
"C" Function
Scale factor between the external
frequency command on terminals
L–O (voltage input) and the
frequency output,
range is 0.0 to 200%
0100.0%
Scale factor between the external
frequency command on terminals
L–OI (voltage input) and the
frequency output,
0100.0%
range is 0.0 to 200%
Offset adjustment of AM output.
Range is 0.0 to 10.0
Adjust together with B080 (AM
gain adjustment)
0000.0V
- See page 3-40, 4-55
Freq setpoint
Max. freq
200%
Max. freq /2
0
0V, 4mA
Description
for details.
3 61
3 61
100%
50%
5V, 12mA 10V, 20mA
Run Defaults
Mode
-FE -FU
Units
Edit (EU) (USA)
100.0 100.0 %
100.0 100.0 %
0.0 0.0 V