Hitachi X200 Series Instruction Manual page 116

Func. Name /
Code SRW Display
B001 Selection of automatic restart
mode
IPS POWR
B002 Allowable under-voltage
power failure time
IPS Time
B003 Retry wait time before motor
restart
IPS Wait
B004 Instantaneous power failure /
under-voltage trip alarm
enable
IPS TRIP
B005 Number of restarts on power
failure / under-voltage trip
events
IPS RETRY
Frequency Pull-in Restart
Func. Name /
Code SRW Display
B011 Start freq to be used in case
of frequency pull-in restart
FSch Md
B029 Deceleration rate of
frequency pull-in restart
setting
FSch CNS
B030 Current level of frequency
pull-in restart setting
FSch LVL
"B" Function
Select inverter restart method,
Four option codes:
00 Alarm output after trip, no
automatic restart
01 Restart at 0Hz
02 Resume operation after
frequency pull-in
03 Resume previous freq. after
freq. pull-in, then decelerate
ALM
to stop and display trip info
The amount of time a power
input under-voltage can occur
without tripping the power
failure alarm. Range is 0.3 to 25
sec. If under-voltage exists longer
than this time, the inverter trips,
even if the restart mode is
0001.0s selected.
Time delay after under-voltage
condition goes away, before the
inverter runs motor again.
0001.0s Range is 0.3 to 100 seconds.
Two option codes:
00 Disable
01 Enable
OFF
Two option codes:
00 Restart 16 times
01 Always restart
16
"B" Function
Three option codes:
00 freq at previous shutoff
01 start from max. Hz
CUTOFF 02 start from set frequency
Sets the deceleration rate when
frequency pull-in restart, range is
0.1 to 3000.0, resolution 0.1
0000.5s
Sets the current level of
frequency pull-in restart, range is
0.2*inverter rated current to
2.0*inverter rated current,
resolution 0.1
002.60A
Description
Description
3 33
3 33
Defaults
Run
Mode -FE -FU
Units
Edit
(EU) (USA)
00 00
1.0 1.0 sec.
1.0 1.0 sec.
00 00
00 00
Run Defaults
Mode -FE -FU
Units
Edit (EU) (USA)
00 00
0.5 0.5 sec.
Rated A
current