3–52
"C" Group: Intelligent Terminal Functions
Analog Signal Calibration Settings
The functions in the following table configure the signals for the analog output termi-
nals. Note that these settings do not change the current/voltage or sink/source character-
istics—only the zero and span (scaling) of the signals.
Func.
Code
SRW Display
C081 O input span calibration Scale factor between the
O-ADJ
C082 OI input span calibra-
tion
OI-ADJ
C085 Thermistor input tuning Range is 0.0 to 200.0%
PTC Adj
C086 [AM] terminal offset
tuning
AM-OFFST 0000.0V
NOTE: When you restore factory default settings, the values will change to those listed
above. Be sure to manually reconfigure the values for your application, if needed, after
restoring factory defaults.
"C" Function
Name /
external frequency command
0100.0%
on terminals L – O (voltage
input) and the frequency
output, range is 0.0 to 200.0%
Scale factor between the
external frequency command
on terminals L – OI (current
0100.0%
input) and the frequency
output, range is 0.0 to 200.0%
0100.0%
Range is 0.0 to 10.0V
Run
Mode
Description
Edit
Defaults
–FEF
–FU
Units
(EU)
(USA)
100.0
100.0
%
100.0
100.0
%
100.0
100.0
%
0.0
0.0
V