Hitachi X200 Series Instruction Manual page 274

The following table lists the holding registers for the "B" Group Fine Tuning Functions.
Func.
Name
Code
B001 Selection of automatic
restart mode
B002 Allowable under-
voltage power failure
time
B003 Retry wait time before
motor restart
B004 Instantaneous power
failure / under-voltage
trip alarm enable
B005 Number of restarts on
power failure / under-
voltage trip events
B011 Start freq to be used in
case of freq pull-in
restart
B012 Level of electronic
thermal setting
B212 Level of electronic
thermal setting, 2nd
motor
B013 Electronic thermal
characteristic
B213 Electronic thermal
characteristic, 2nd
motor
List of Holding Registers
R/W Description
R/W Select inverter restart method,
Four option codes:
00 Alarm output after trip, no
automatic restart
01 Restart at 0Hz
02 Resume operation after
frequency matching
03 Resume previous freq. after
freq. matching, then
decelerate to stop and
display trip info
R/W The amount of time a power
input under-voltage can occur
without tripping the power
failure alarm. Range is 0.3 to 25
sec. If under-voltage exists
longer than this time, the
inverter trips, even if the restart
mode is selected.
R/W Time delay after under-voltage
condition goes away, before the
inverter runs motor again.
Range is 0.3 to 100 seconds.
R/W Two option codes:
00 Disable
01 Enable
R/W Two option codes:
00 Restart 16 times
01 Always restart
R/W Three option codes:
00 freq at previous shutoff
01 start from max. Hz
02 start from set frequency
R/W Set a level between 20% and
100% for the rated inverter
current.
R/W
R/W Select from three curves, option
codes: *1
00 Reduced torque 1
R/W
01 Constant torque
02 Reduced torque 2
B 31
B 31
Network Data
Reg. Range Res.
10A5h 0, 1, 2, 3
10A6h 3 to 250 0.1 sec
10A7h 3 to 1000 0.1 sec
10A8h 0, 1
10A9h 0, 1
1170 0, 1, 2
10ADh 2000 to 0.01 %
10000
1527h
10AEh 0, 1, 2
1528h