Front Housing Cover; Housing Cover Removal - Hitachi X200 Series Instruction Manual

Front Housing Cover

HIGH VOLTAGE: Hazard of electrical shock. Disconnect incoming power before
working on this control. Wait five (5) minutes before removing the front cover.
Housing Cover Removal – The front housing cover is held in place by a screw and two
pairs of tabs. Since these tabs are hidden from view, it is good to become familiar with
their locations
housing cover in an upside-down position to reveal the tabs. The two locking tabs are
the ones which you will need to press to remove the cover. The two hinging tabs will
allow the cover to tilt open after the locking tabs are released.
Locking tabs
NOTE: Use care when removing the knock-out for the communication connector
(indicated by A in above figure). After removal of the knock-out, some burrs may remain.
Carefully file them smooth, if necessary.
The figure below shows the procedure for removing the housing cover. First, unscrew the
screw, squeeze the side locking tabs, and then lift up the housing cover. DO NOT force
the cover open; it is possible to break a tab in this way.
1. Unscrew the screw
before
attempting to remove the cover. The figure below shows a typical
Hinging tabs
A
2. Lift up the bottom side of the cover
2 3
2 3