Ip Version 6 Ethernet Configuration Parameters - Qlogic SANbox 5802V Interface Manual

14 – Command Reference
Set Setup System
ipv4
Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet
configuration parameters described in
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
ipv6
Prompts you in a line-by-line fashion to change the switch IP version 6 Ethernet
configuration parameters described in
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
EthIPv6NetworkEnable
EthIPv6NetworkDiscovery
EthIPv6NetworkAddress
14-124
Table 14-32. IP Version 4 Ethernet Configuration Parameters
Entry
Enables (True) or disables (False) the IP version 4 inter-
face. The default is True.
Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Ethernet IP address. The default is 10.0.0.1.
Ethernet IP subnet mask address. The default is
255.0.0.0.
Ethernet address gateway. The default is 10.0.0.254
Table 14-33. IP Version 6 Ethernet Configuration Parameters
Entry
Enables (True) or disables (False) the IP version 6 inter-
face. The default is True.
Ethernet boot method: 1 – Static, 2 – DHCPv6, 3 – NDP.
The default is 1 - Static.
Ethernet IP address
Table 14-32. To configure all system
Description
Table 14-33. To configure all system
Description
S
59263-01 A