Ipsec Policy - Qlogic SANbox 5802V Interface Manual

A

Ipsec Policy

Manages policies in the Security Policy database.
Authority
Admin session and an Ipsec Edit session
Syntax
ipsec policy
copy [policy_source] [policy_destination]
create [policy]
delete [policy]
edit [policy]
list [option]
rename [policy_old] [policy_new]
Keywords
copy [policy_source] [policy_destination]
Creates a new policy named [policy_destination] and copies the configuration into
it from the policy given by [policy_source]. You must enter the Ipsec Save
command afterwards to save your changes. [policy_destination] must not begin
with DynamicSP_, which is reserved for dynamic policies.
create [policy]
Creates a policy with the name given by [policy]. A policy name must begin with a
letter and be no longer than 32 characters. Valid characters are 0-9, A-Z, a-z, _, $,
^, and -. The Security Policy database supports a maximum of 128 user-defined
policies. You must enter the Ipsec Save command afterwards to save your
changes.
Parameter
Description
SourceAddress
SourcePort
DestinationAddress
DestinationPort
59263-01 A
Table 14-7 describes the policy parameters:
Table 14-7. Policy Configuration Parameters
Description of the policy
IP address (version 4 or 6) or DNS host name of the host,
switch, or gateway from which data originates.
Source port number (1–65535)
IP address (version 4 or 6) or DNS host name of the host,
switch, or gateway receiving data. If you specified an IP address
for the SourceAddress, the DestinationAddress must use the
same IP version format.
Destination port number (1–65535)
14 – Command Reference
Description
Ipsec Policy
14-53