Set Setup Snmp - Qlogic SANbox 5802V Interface Manual

A

Set Setup SNMP

Configures SNMP on the switch.
Authority
Admin session
Syntax
set setup snmp
common
trap [trap_number]
Keywords
common
Prompts you in a line-by-line fashion to change SNMP configuration parameters
that are common for all traps. For each parameter, enter a new value or press the
Enter key to accept the current value. To configure common parameters and trap
parameters, omit the Common keyword. Refer to
the SNMP trap parameters.
configuration parameters.
Parameter
SNMPEnabled
Contact
Location
ReadCommunity
WriteCommunity
59263-01 A
Table 14-29
Table 14-29. SNMP Common Configuration Parameters
Enables (True) or disables (False) SNMP on the switch. The
default is True.
Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding #,
semicolon (;), and comma (,). The default is undefined. This
value is also passed to the Call Home service configuration.
Specifies the name of the switch location. The name can be up
to 64 characters excluding #, semicolon (;), and comma (,).
The default is undefined. This value is also passed to the Call
Home service configuration.
Read community password that authorizes an SNMP agent to
read information from the switch. This is a write-only field. The
value on the switch and the SNMP management server must
be the same. The read community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is "public".
Write community password that authorizes an SNMP agent to
write information to the switch. This is a write-only field. The
value on the switch and the SNMP management server must
be the same. The write community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is "private".
14 – Command Reference
Table 14-30
describes the common SNMP
Description
Set Setup SNMP
for a description of
14-119