Setting The Date And Time Through Ntp - Qlogic SANbox 5802V Interface Manual

A

Setting the Date and Time through NTP

An NTP server can automatically set the switch date and time. To configure the
switch to use an NTP server, enter the
Admin session to enable the NTP client on the switch and specify the NPT server
IP address, as shown in the following example:
SANbox (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled
NTPServerDiscovery
NTPServerAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled
NTPServerDiscovery
NTPServerAddress
Do you want to save and activate this system setup? (y/n): [n] y
59263-01 A
Set Setup System Ntp
False
Static
10.20.10.10
(True / False)
(1=Static, 2=Dhcp, 3=Dhcpv6)
(hostname, IPv4, or IPv6 Address) : 10.20.3.4
5 – Switch Configuration
Setting the Date and Time
command in an
: True
:
5-19