Set Config Security - Qlogic SANbox 5802V Interface Manual

14 – Command Reference

Set Config Security

Set Config Security
NOTE:
This command requires the Fabric Security license key. To purchase a
license key, contact your authorized maintenance provider or authorized
reseller. Use the
Configures the security database for the automatic saving of changes to the active
security set and fabric binding. The changes you make with this command are not
retained when you reset or power cycle the switch unless you save them using the
Config Save command.
Authority
Admin session and a Config Edit session
Syntax
set config security
This command initiates an editing session in which to change the security
database configuration. The system displays each parameter one line at a time
and prompts you for a value. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter "q" or "Q" to end
the editing session.
AutoSave
FabricBindingEnabled
14-92
Feature
Table 14-20
Table 14-20. Security Configuration Parameters
Parameter
Enables (True) or disables (False) the saving of changes
to active security set in the switch's permanent memory.
The default is True.
Enables (True) or disables (False) the configuration and
enforcement of fabric binding on all switches in the fabric.
Fabric binding associates switch worldwide names with a
domain ID in the creation of ISL groups. The default is
False.
command to install a license key.
describes the security configuration parameters.
Description
S
59263-01 A