Modifying A User-Defined Association - Qlogic SANbox 5802V Interface Manual

A

Modifying a User-Defined Association

To modify an existing user-defined association, enter the
command in an Admin session and an Ipsec Edit session as shown in the
following example. An asterisk (*) indicates a required entry.
SANbox (admin-ipsec) #> ipsec association edit h2h-sh-sa
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
To remove a value for an optional attribute, use 'n'.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Description
.
.
EncryptionKey
New Value (press ENTER to not specify value, 'q' to quit, 'n' for none):
Description
*SourceAddress
*DestinationAddress
*Protocol
*SPI
Authentication
*AuthenticationKey
*Encryption
*EncryptionKey
The security association has been edited.
This configuration must be saved with the 'ipsec save' command
before it can take effect, or to discard this configuration
use the 'ipsec cancel' command.
SANbox (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
59263-01 A
Host-to-host: switch->host
123456789012345678901234
(string value, 0-127 bytes)
(IPv4, IPv6 or hostname)
(IPv4, IPv6 or hostname)
(1=esp, 2=esp-old, 3=ah, 4=ah-old)
(decimal value, 256-4294967295)
(select an authentication algorithm)
1=hmac-md5 (16 byte key)
2=hmac-sha1 (20 byte key)
3=hmac-sha256 (32 byte key)
4=aes-xcbc-mac (16 byte key)
authentication algorithm choice
(quotes string or raw hex bytes)
(select an encryption algorithm)
1=des-cbc (8 byte key)
2=3des-cbc (24 byte key)
3=null (0 byte key)
4=blowfish-cbc (5-56 byte key)
5=aes-cbc (16/24/32 byte key)
6=twofish-cbc (32 byte key)
encryption algorithm choice
(quoted string or raw hex bytes)
4 – Network Configuration
Managing IP Security
Ipsec Association Edit
:
:
:
: ah
:
:
:
:
:
4-17