Setting The Date And Time Explicitly - Qlogic SANbox 5802V Interface Manual

5 – Switch Configuration
Setting the Date and Time

Setting the Date and Time Explicitly

To set the switch date and time explicitly, use the
commands. To change the time zone (to America/North Dakota, for example),
enter the Set Timezone command in an Admin session, as shown in the following
example:
SANbox #> admin start
SANbox (admin) #> set timezone
Africa
Antarctica
Atlantic
Europe
Pacific
America/Grenada
America/Guatemala
America/Guyana
America/Havana
America/Indiana
.
.
.
America/Monterrey
America/Montreal
America/Nassau
America/Nipigon
America/Noronha
America/Panama
q
Enter selection (or 'q' to quit): america/north_dakota
America/North_Dakota/Center
Enter selection (or 'q' to quit): america/north_dakota/center
To set the date and time (January 31, 10:15 AM, 2008), enter the date command,
as shown in the following example:
SANbox (admin) #> date 013110152008
SANbox (admin) #> date
Thu Jan 31 10:15:03 america/north_dakota/center 2008
5-18
Press ENTER for more options or 'q' to make a selection.
Press ENTER for more options or 'q' to make a selection.
Set Timezone
America
Asia
Australia
Indian
UTC
America/Guadeloupe
America/Guayaquil
America/Halifax
America/Hermosillo
America/Indianapolis
America/Montevideo
America/Montserrat
America/New_York
America/Nome
America/North_Dakota
America/Pangnirtung
S
and Date
59263-01 A