Connectivity Tests For Switches - Qlogic SANbox 5802V Interface Manual

A

Connectivity Tests for Switches

A connectivity test is a disruptive test that exercises all port and inter-port
connections for a switch in the diagnostics state. You must place the switch in the
diagnostics state using the
There are two types of connectivity test: internal loopback and external loopback.
An internal loopback test exercises all internal port and inter-port
connections.
An external loopback test exercises all internal port, transceiver, and
inter-port connections. A transceiver with a loopback plug is required for all
ports.
The following example performs a connectivity internal test on a switch:
SANbox #> admin start
SANbox (admin) #>set switch state diagnostics
SANbox (admin) #> test switch connectivity internal
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
LoopCount
FrameSize
DataPattern
StopOnError
LoopForever
Do you want to start the switch test? (y/n): [n] y
When the test is complete, remember to place the switch back online. The switch
resets when it leaves the diagnostics state.
SANbox (admin) #> set switch state online
59263-01 A
Set Switch State
(decimal value, 1-4294967295)
(decimal value, 40-2148)
(32-bit hex value or keyword 'Default')
(True / False)
(True / False)
5 – Switch Configuration
command before starting the test.
[100
[256
[Default]
[True
[False
Testing a Switch
]
]
]
]
5-27