B-9 Set Config Port Parameters; Set Config Command - Qlogic SANbox 1400 Series Installation Manual

B – Command Line Interface

Set Config Command

Set Config Command
Sets switch, port, port threshold alarm, and zoning configuration parameters. The
changes you make with this command are not retained when you reset or power
cycle the switch unless you save them using the Config Save command. Refer to
the "Config Command" on page
Authority
Admin session and a Config Edit session
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter "q" to end the configuration for one port, or "qq" to end the configuration for
all ports.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter "q" to end the
configuration.
AdminState
B-40
Table B-9 describes the port parameters.
Table B-9 describes the port parameters.
Table B-9. Set Config Port Parameters
Parameter
Port administrative state:
B-11.
Description
Online – Activates and prepares the port to send
data. This is the default.
Offline – Prevents the port from receiving signal and
accepting a device login.
Diagnostics – Prepares the port for testing and pre-
vents the port from accepting a device login.
Down – Disables the port by removing power from
the port lasers.
S
59225-00 B