D
Set Config Command
Sets switch, port, alarm threshold, and zoning configuration parameters.
Authority
Admin authority and a Config Edit session
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter "q" to end the configuration for one port, or "qq" to end the configuration for
all ports.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter "q" to end the
configuration.
AdminState
LinkSpeed
PortType
ISLSecurity
59042-03 A
Table B-9
describes the port parameters.
Table B-9
describes the port parameters.
Table B-9. Set Config Port Parameters
Parameter
B – Command Line Interface
Set Config Command
Description
Port administrative state: online, offline,
diagnostics, or down. The default is
online.
Transmission speed: 1Gb/sec, 2
Gb/sec, or Auto. The default is Auto.
Port mode: TL, GL, G, F, FL, Donor. The
default is GL.
E_Port security. Determines which
switches a port will establish a link with.
Any - link with any FC-SW-2
compliant switch. This is the
default.
Ours - link only with an FC-SW-2
compliant QLogic switch.
None - reject the link.
B-29