Device Tab: Software Module Configurator - Qlogic 12000 Series User Manual

Figure 1-25 Device Tab: Software Module Configurator
To change any Log Level settings:
1. Click the On-Off check box to the right of the setting.
2. Click the Apply button to save any changes.
The following list describes each of the Log Level configuration parameters.
DUMP – Dump: Indicates that a problem has caused the system to produce
a system dump file. In most circumstances, it is recommended that the user
retrieve the dump that was produced. Support engineers may require the
information contained in the dump file to diagnose the cause of the problem.
FATAL – Indicates that a non-recoverable system problem has occurred.
The user should reboot the system or component and verify that the
subsystem is fully functional to determine whether the fault has been
corrected. If the problem persists, the user should contact the supplier.
ERROR – Indicates that a serious system error has occurred which might be
recoverable. If the system exhibits any instability, the user should reboot the
system or component. If errors persist, the user should immediately contact
the supplier's technical support.
D000101-000 E
1–Operations and Administration
Configuration and Monitoring Features
1-17