Qlogic 12000 Series User Manual page 41

Port
Specifies the TCP or UDP port that the SNMP trap is sent.
Timeout
Specifies the time (in milliseconds) that the trap sender waits on a response
before re-sending the trap.
Retry Count
Specifies the number of attempts to be made to send the trap after a timeout
condition occurs.
NOTE:
Tag List
Specifies which traps should be sent to this particular destination.
NOTE:
Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table,
determining the version of SNMP to use.
Storage Type
This field determines whether or not the entry is saved for each reboot of the
switch.
Status
Indicates the current status of the row. The row may be in one of three
states:
D000101-000 E
Timeout and Retry Count are SNMP v2.c and above. Not applicable for
v1 traps.
RFC2233 specifies the link up/down traps. Including RFC2233 in the
Tag List specifies that the trap receiver will get link up/down traps.
Nonvolatile means that the value is saved, and remains with each
subsequent reboot.
Volatile or Other indicates it will not be saved.
Active
Not in service
Not Ready
1–Operations and Administration
Configuration and Monitoring Features
1-29