Dell Networking 7048 Configuration Manual page 717

Unit and Ports — Displays and assigns multicast group membership to
•
ports. To assign membership, click in Static for a specific port. Each click
toggles between S, F, and blank. See Table 25-2 for definitions.
LAGs — Displays and assigns multicast group membership to LAGs. To
•
assign membership, click in Static for a specific LAG. Each click toggles
between S, F, and blank. See Table 25-2 for definitions.
Table 25-2 contains definitions for port/LAG IGMP management settings.
Table 25-2. Port/LAG IGMP Management Settings
Port Control Definition
D Dynamic: Indicates that the port/LAG was dynamically joined to
the Multicast group (displays in the
S Static: Attaches the port to the Multicast group as a static member
in the
F Forbidden: Indicates that the port/LAG is forbidden entry into the
Multicast group in the
Apply is clicked.
Blank Blank: Indicates that the port is not attached to a Multicast group.
Adding and Configuring Bridge Multicast Address Groups
To configure a bridge multicast group:
1 From the Bridge Multicast Group page, click Add.
The Add Bridge Multicast Group page displays.
Static
row. Displays in the
Static
Configuring L2 Multicast Features
Current
row).
Current
row once Apply is clicked.
row. Displays in the
Current
row once
717