Port Configuration Examples; Configuring Port Settings - Dell Networking 7048 Configuration Manual

Port Configuration Examples

This section contains the following examples:
•

Configuring Port Settings

• Configuring a Link Dependency Groups
Configuring Port Settings
The commands in this example specify the speed and duplex mode for port 1
(gigabitethernet 1/0/1) and change the MTU size for ports 10, 11, 12, 20, and
25.
To configure the switch:
1 Enter Interface Configuration mode for port 1.
console#configure
console(config)#interface gigabitEthernet 1/0/1
2 Change the speed and duplex settings for the port.
console(config-if-Gi1/0/1)#speed 100
console(config-if-Gi1/0/1)#duplex full
console(config-if-Gi1/0/1)#exit
3 Enter Interface Configuration mode for ports 10, 11, 12, 20, and 24.
console(config)#interface range gigabitEthernet
1/0/10-12,1/0/20,1/0/24
4 Enable jumbo frame support on the interfaces.
console(config-if)#mtu 9216
console(config-if)#CTRL + Z
5 View summary information about the ports
console#show interfaces configuration
Port
---------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/4
Gi1/0/5
--More-- or (q)uit
Type
-------------
Gigabit - Level
Gigabit - Level
Gigabit - Level
Gigabit - Level
Gigabit - Level
Duplex Speed
------ -------
Full 100
N/A Unknown
N/A Unknown
N/A Unknown
N/A Unknown
Configuring Port Characteristics
Neg Admin St.
---- -----
Off Up
Auto Up
Auto Up
Auto Up
Auto Up
479