Configuring And Viewing Igmp - Dell Networking 7048 Configuration Manual

Configuring and Viewing IGMP

Beginning in Privileged EXEC mode, use the following commands to
configure IGMP on the switch and on VLAN routing interfaces and to view
IGMP information.
Command
configure
ip multicast
ip igmp
vlan-id
interface vlan
ip igmp
ip igmp version
ip igmp robustness
robustness
ip igmp query-interval
seconds
ip igmp query-max-
response-time
ip igmp startup-query-
seconds
interval
1222
Managing IPv4 and IPv6 Multicast
Purpose
Enter global configuration mode.
Enable IPv4/IPv6 multicast routing.
Enable IGMP on the switch.
Enter Interface Configuration mode for the specified
VLAN.
Enable IGMP on the interface.
version
Set the version of IGMP for an interface.
version
The
Configure the robustness that allows tuning of the
interface, that is, tuning for the expected packet loss on a
subnet. If a subnet is expected to have significant loss, the
robustness variable may be increased for the interface.
The range for
Configure the query interval for the specified interface.
The query interval determines how fast IGMP Host-
Query packets are transmitted on this interface.
The range for
Configure the maximum response time interval for the
seconds
specified interface. It is the maximum query response
time advertised in IGMPv2 queries on this interface.
The range for
Set the interval between general queries sent at startup on
the interface.
The range for
variable can be 1, 2, or 3.
robustness
is 1–255.
seconds
is 0–3600 seconds.
seconds
is 0–25 seconds.
seconds
is 0–300 seconds.