Default Rip Values - Dell Networking 7048 Configuration Manual

Default RIP Values

RIP is globally enabled by default. To make it operational on the router, you
configure and enable RIP for particular VLAN routing interfaces.
Table 35-1 shows the global default values for RIP.
Table 35-1. RIP Global Defaults
Parameter
Admin Mode
Split Horizon Mode
Auto Summary Mode
Host Routes Accept Mode
Default Information Originate
Default Metric
Route Redistribution
Table 35-2 shows the per-interface default values for RIP .
Table 35-2. RIP Per-Interface Defaults
Parameter
Admin Mode
Send Version
Receive Version
Authentication Type
Default Value
Enabled
Simple
Disabled
Enabled
Disabled
None configured
Disabled for all sources.
Default Value
Disabled
RIPv2
Both
None
Configuring RIP
1021