Candidate Rp Configuration - Dell Networking 7048 Configuration Manual

Candidate RP Configuration

The Candidate RP is configured on the Add Candidate RP page. Use the
Candidate RP Configuration page to display and delete the configured
rendezvous points (RPs) for each port using PIM.
To access the page, click IPv4 Multicast → PIM → Candidate RP
Configuration or IPv6 Multicast → PIM → Candidate RP Configuration.
Figure 42-40. Candidate RP Configuration
Adding a Candidate RP
To add PIM Candidate rendezvous points (RPs) for each IP multicast group:
1 Open the Candidate RP Configuration page.
2 Click Add.
The Add Candidate RP page displays.
1204
Managing IPv4 and IPv6 Multicast