Configuring L2 Multicast Features (Web); Multicast Global Parameters - Dell Networking 7048 Configuration Manual

Configuring L2 Multicast Features (Web)

This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring L2 multicast features on
a PowerConnect 7000 Series switch. For details about the fields on a page,
click at the top of the page.

Multicast Global Parameters

Use the Multicast Global Parameters page to enable or disable bridge
multicast filtering, IGMP snooping, or MLD snooping on the switch.
To display the Multicast Global Parameters page, click Switching →
Multicast Support → Global Parameters in the navigation menu.
Figure 25-1. Multicast Global Parameters
NOTE:
It is strongly recommended that users enable IGMP snooping if MLD
snooping is enabled and vice-versa. This is because both IGMP snooping and
MLD snooping utilize the same forwarding table, and not enabling both may
cause unwanted pruning of protocol packets utilized by other protocols, e.g.
OSPFv2.
Configuring L2 Multicast Features
715