Configuring Global Lldp Settings; Configuring Port-Based Lldp Settings - Dell Networking 7048 Configuration Manual

Configuring Global LLDP Settings

Beginning in Privileged EXEC mode, use the following commands to
configure LLDP settings that affect the entire switch.
Command
configure
lldp notification-
interval
interval
lldp timers [interval
transmit-interval
hold-value
] [reinit
delay
]
exit
show lldp

Configuring Port-based LLDP Settings

Beginning in Privileged EXEC mode, use the following commands to
configure per-port LLDP settings.
Command
configure
interface
interface
lldp transmit
lldp receive
lldp transmit-mgmt
680
Discovering Network Devices
Purpose
Enter Global Configuration mode.
Specify how often, in seconds, the switch should send
remote data change notifications.
Configure the timing for local data transmission on ports
enabled for LLDP.
] [hold
reinit-
transmit-interval —
•
transmit local data LLDP PDUs. (Range: 5–32768
seconds)
hold-value —
•
set the TTL in local data LLDP PDUs. (Range: 2–10)
reinit-delay —
•
initialization. (Range: 1–10 seconds)
Exit to Privileged EXEC mode.
View global LLDP settings.
Purpose
Enter Global Configuration mode.
Enter interface configuration mode for the specified
Ethernet interface.
Enable the LLDP advertise (transmit) capability.
Enable the LLDP receive capability so that the switch can
receive LLDP Protocol Data Units (LLDP PDUs) from
other devices.
Include the transmission of local system management
address information in the LLDP PDUs.
The interval in seconds at which to
Multiplier on the transmit interval used to
The delay in seconds before re-