Default L2/L3 Relay Values - Dell Networking 7048 Configuration Manual

Default L2/L3 Relay Values

By default L2 DHCP relay is disabled. L3 relay (UDP) is enabled, but no UDP
destination ports or server addresses are defined on the switch or on any
interfaces.
Table 33-3. L2/L3 Relay Defaults
Parameter
L2 DHCP Relay
Admin Mode
Trust Mode
Circuit ID
Remote ID
L3 DHCP Relay
UDP Relay Mode (IP Helper)
Hop Count
Minimum Wait Time
Circuit ID Option Mode
Circuit ID Check Mode
Information Option-Insert
Information Check-Reply
Default Value
Disabled globally and on all interfaces and
VLANs
Disabled on all interfaces
Disabled on all VLANs
None configured
Enabled
4
0 seconds
Disabled
Enabled
Disabled on all VLAN interfaces
Enabled on all VLAN interfaces
Configuring L2 and L3 Relay Features
913