Configuring Route Redistribution Settings - Dell Networking 7048 Configuration Manual

Configuring Route Redistribution Settings

Beginning in Privileged EXEC mode, use the following commands to
configure an OSPF area range and to configure route redistribution settings.
Command
configure
router rip
distribute-list
accesslistname
out {ospf |
static | connected}
redistribute {static |
connected} [metric
integer
]
Purpose
Enter global configuration mode.
Enter RIP configuration mode.
Specify the access list to filter routes received from the
source protocol. The ACL must already exist on the
switch. For information about the commands you use to
configure ACLs, see "Configuring ACLs (CLI)" on
page 543.
accesslistname
• — The name used to identify an existing
ACL.
• ospf — Apply the specified access list when OSPF is the
source protocol.
• static — Apply the specified access list when packets
come through the static route.
• connected — Apply the specified access list when
packets come from a directly connected route.
Configure RIP to allow redistribution of routes from the
specified source protocol/routers.
• static — Specifies that the source is a static route.
• connected — Specifies that the source is a directly
connected route.
metric
• — Specifies the metric to use when
redistributing the route. Range: 1-15.
Configuring RIP
1029