Configuring Mep Information - Dell Networking 7048 Configuration Manual

Configuring MEP Information

Beginning in Privileged Exec mode, use the following commands to configure
the mode and view related settings.
CLI Command
configure
interface
interface
ethernet cfm mep enable level
level vlan-id
vlan
ethernet cfm mep level
direction {up | down} mpid
mep-id vlan-id
vlan
ethernet cfm mep active
ethernet cfm mip level
exit
show ethernet cfm
maintenance–points
show ethernet cfm statistics
776
Configuring Connectivity Fault Management
Description
Enter global configuration mode.
Enter Interface Config mode for the specified
interface, where
gigabitethernet
unit/slot/port
Define the port as a maintenance endpoint (MEP)
mep-id
mpid and associate it with an SVLAN in a domain. When
the MEP is enabled, it will generate CCM messages.
level
Enable a MEP at the specified level and direction.
Set the administrative state of the MEP to active.
level
Create a MIP at the specified level on the interface.
Exit to privileged Exec Mode
Add the keywords local domain, local interface,
local level, remote domain, or remote level to show
information on local or remote endpoints.
Display statistics per MEP .
interface
is replaced by
unit/slot/port
, or tengigabitethernet
.