What Configuration Is Required For Plug-In Modules; What Are The Key Poe Plus Features For The Pc7024P And Pc7048P - Dell Networking 7048 Configuration Manual

To increase security, you can require authentication between the configured
SNTP server and the SNTP client on the switch. Authentication is provided
by Message Digest 5 (MD5). MD5 verifies the integrity of the
communication and authenticates the origin of the communication.

What Configuration Is Required for Plug-In Modules?

The switch supports several different plug-in modules (also known as cards)
for the expansion slots located on the back of the switch. For information
about the slots and the supported modules, see "Expansion Slots for Plug-in
Modules" on page 92. You can preconfigure the card type prior to inserting it
into the switch.
Hot-swap is supported on the PC7000 switch. However, the switch must be
rebooted.
Hot-swap support is not available for plug-in modules, which means the
switch requires a reboot when you insert or remove cards. Additionally, the
switch must be powered off to change the role of the ports on a module from
stacking to Ethernet or vice-versa. Modules operate in the mode for which
they are configured as a default. This means that the module configuration
(Ethernet or stacking) does not appear in the running-config.
Before inserting a new module into the expansion slot that was previously
occupied by a different type of module, issue a no slot or clear config
command from the CLI so that the switch can recognize the new module.

What Are the Key PoE Plus Features for the PC7024P and PC7048P?

Table 11-4 describes some of the key PoE Plus features the switches support.
Table 11-4. PoE Plus Key Features (7024P and 7048P Only)
Feature
Global Usage
Threshold
Description
Provides the ability to specify a power limit as a percentage
of the maximum power available to PoE ports. Setting a
limit prevents the PoE switch from reaching an overload
condition.
Managing General System Settings
243