Configuring Gvrp - Dell Networking 7048 Configuration Manual

Command
protocol group
vlanid
CTRL + Z
show port protocol [all|
groupid
]

Configuring GVRP

Beginning in Privileged EXEC mode, use the following commands to enable
GVRP on the switch and on an interface, and to configure various GVRP
settings.
Command
configure
gvrp enable
interface
interface
gvrp enable
610
Configuring VLANs
Purpose
groupid
Attach a VLAN ID to the protocol-based group identified
by groupid. A group may only be associated with one
VLAN at a time. However, the VLAN association can be
changed.
groupid
•
automatically generated when you create a protocol-
based VLAN group with the vlan protocol group
command. To see the group ID associated with the name
of a protocol group, use the show port protocol all
command.
vlanid
•
Exit to Privileged EXEC mode.
Display the Protocol-Based VLAN information for either
the entire system or for the indicated group.
Purpose
Enter global configuration mode.
Enable GVRP on the switch.
Enter interface configuration mode for the specified port
or LAG. The
and number, for example gigabitethernet 1/0/3 or port-
channel 3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
Enable GVRP on the interface.
— The protocol-based VLAN group ID, which is
— A valid VLAN ID.
interface
variable includes the interface type