Configuring A Static Address Pool - Dell Networking 7048 Configuration Manual

Configuring a Static Address Pool

Beginning in Privileged EXEC mode, use the following commands to create a
static address pool and specify the network information for the pool. The
network information configured in the static address pool is assigned only to
the host with the hardware address or client identifier that matches the
information configured in the static pool.
Command
configure
name
ip dhcp pool
name
client-name
hardware-address
type
[ ]
client-identifier
uniqueidentifier
address mask
host [
prefix-length
]
duration
lease [
infinite}]
876
Configuring DHCP Server Settings
Purpose
Enter Global Configuration mode.
Create a DHCP address pool and enters DHCP pool
configuration mode.
Specify the DHCP client name.
mac
Specify the hardware address of the client in the static
pool.
mac
• —MAC address of the hardware platform of the
client consisting of 6 bytes in dotted hexadecimal format.
type
•
It is 1 for Ethernet and 6 for IEEE 802.
Specify the unique identifier for a DHCP client. The
unique-identifier is a valid notation in hexadecimal
format.
In some systems, such as Microsoft DHCP clients, the
client identifier is required instead of hardware addresses.
The unique-identifier is a concatenation of the media type
and the MAC address. For example, the Microsoft client
identifier for Ethernet address c819.2488.f177 is
01c8.1924.88f1.77 where 01 represents the Ethernet media
type.
| Specify the IP address and (optionally) network mask for a
manual binding to a DHCP client.
] | Specify the duration of the lease for an IP address that is
assigned from a DHCP server to a DHCP client.
duration
•
specify the hours and minutes after specifying the days.
• infinite — 60 day lease
— Indicates the protocol of the hardware platform.
— Days the lease is valid. You can optionally