Technical Specifications - Owon SDS series User Manual

8. Technical Specifications

Unless otherwise specified, the technical specifications applied are for SDS series
only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following
two conditions at first, these specification standards can be reached.
This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
If change of the operating temperature is up to or exceeds 5 ,
"Self-calibration" procedure (see "How to Implement Self-calibration" on P15).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel
Acquisition
Input
8.Technical Specifications
Mode
Sample rate
(real time)
Input coupling
Input impedance
Probe attenuation
factor
Max. input voltage
Bandwidth limit
Instruction
SDS6062(V)
SDS7102(V)
SDS8102(V)
SDS8202(V)
SDS8302
SDS9302
2 + 1 (External)
Normal, Peak detect, Averaging
Dual CH
SDS6062(V)
Single CH
Dual CH
SDS7102(V)
Single CH
Dual CH
SDS8102(V)
Single CH
Dual CH
SDS8202(V)
Single CH
Dual CH
SDS8302
Single CH
Dual CH
SDS9302
Single CH
DC, AC , Ground
1MΩ±2%, in parallel with 10pF±5pF
1X, 10X, 100X, 1000X
400V (PK-PK) (DC + AC PK-PK)
20MHz, full bandwidth
(not including SDS6062(V) )
86
℃ do a
60MHz
100MHz
100MHz
200MHz
300MHz
300MHz
250MS/s
500MS/s
500MS/s
1GS/s
1GS/s
2GS/s
1GS/s
2GS/s
1.25GS/s
2.5GS/s
1.6GS/s
3.2GS/s