How To Measure Automatically - Owon SDS series User Manual

(4) Set the network parameters of the oscilloscope. In the oscilloscope, press the
Utility button and press H1 button, turn the M knob to select the LAN Set; press
the H2 button, the set menu is displayed on the right. Set the IP and the Port to
the same value as the "Ports-settings" in the software in step (3). The Netgate and
Net mask should be set according to the router. Press the H3 button to select
"Save set", it prompts "reset to update the config". After resetting the
oscilloscope, if you can get data normally in the oscilloscope software, the
connection is successful.
Figure 5-55 Set the network parameters of the oscilloscope

How to Measure Automatically

Press the Measure button to display the menu for the settings of the Automatic
Measurements.
The oscilloscopes provide 20 parameters for auto measurement, including Vpp,
Vmax, Vmin, Vtop, Vbase, Vamp, Vavg, Vrms, Overshoot, Preshoot, Freq, Period,
Rise Time, Fall Time, Delay A→B , Delay A→B ,+Width, -Width, +Duty, -Duty.
That's 10 voltage and 10 time measurements in all.
The menu is displayed as Figure 5-56.
5.Advanced User Guidebook
64