Owon SDS series User Manual page 65

● LAN Set
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in the menu below.
Press the Utility button and turn the M knob to select the LAN Set to go to the
following menu.
The description of LAN Set menu is shown as the follows:
Function
Setting
Menu
IP
Port
Netgate
Set
Phy addr
Net mask
Save set Save the current settings and prompt "reset to update the config"
How to connect with a computer directly:
(1) Connection. Plug in the LAN line to the LAN port in the right side panel of the
oscilloscope; plug the other end into the LAN interface of the computer.
(2) Set the network parameters of the computer. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP
address. Here we set the IP address to 192.168.1.71.
5.Advanced User Guidebook
Figure 5-49 LAN Set menu
Description
Press F1 button to switch between each byte, turn the M knob
to change value (0～255)
Turn the M knob to change value (0～4000)
Press F3 button to switch between each byte, turn the M knob
to change value (0～255)
Press F4 button to switch between each byte, turn the M knob
to change value (0～FF)
Press F5 button to switch between each byte, turn the M knob
to change value (0～255)
60