Connecting The Cabinet Controller Lan Cable - HP StorageWorks ESL E-Series Installation Manual
Hide thumbs
Also See for StorageWorks ESL E-Series:
- User manual (188 pages) ,
- Replacement instructions (4 pages) ,
- User manual (141 pages)
Table of Contents
Advertisement
Connecting the cabinet controller LAN cable
1.
Route your LAN Ethernet cable up through the bottom of the library cabinet through the cable
access hole on the right side as you face the back of the library.
2.
Attach the cable to the front Ethernet port on the cabinet controller located at the base of the
library. The ports are on the right side toward the back of the cabinet controller (see
NOTE:
There are two Ethernet ports on the right side of the cabinet controller. One port is for the
cable that routes to the service port behind the laptop tray on the front of the library. This cable is
factory installed. The second port should be vacant and is available for connecting to your local
network.
1
Ethernet ports
Figure 46
Connecting the cabinet controller LAN cable
ESL E-Series Tape Library unpacking and installation guide
Figure
46).
1
55
Advertisement
Table of Contents
