Connecting The Cabinet Controller Lan Cable; Connecting Fc Cables - HP StorageWorks ESL E Series Unpacking And Installation Manual

If routing through the top of the cabinet, use a Phillips screwdriver to remove the
plate covering the top access hole. If routing through the bottom of the library
cabinet, route the cable(s) down the left side of the library next to the power cables.
3.
Route the FC cable(s) to a switch or an HBA.
NOTE:
You can connect directly to an HBA or to a switch. The default is to connect to a switch.
For detailed procedures for connecting to an HBA, please see
Interface Manager and Command View TL user guide

Connecting the cabinet controller LAN cable

1.
Route your LAN Ethernet cable up through the bottom of the library cabinet through
the cable access hole on the right side as you face the back of the library.
2. Attach the cable to the front Ethernet port on the cabinet controller located at the
base of the library. The ports are on the right side toward the back of the cabinet
controller (see
52
Installing the library
Figure 31 Connecting FC cables
Figure 32).
HP StorageWorks
.