Save The Running-Configuration - Dell PowerEdge M IO Aggregator Command Reference Manual

Figure 4-10 shows an example of using the
an FTP server.
Figure 4-10. Copying a file from a Remote System
FTOS#copy ftp://myusername:mypassword@10.10.10.10//FTOS/FTOS-EF-8.2.1.0.bin flash://
Destination file name [FTOS-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied

Save the Running-Configuration

The running-configuration contains the current system configuration. Dell Force10 recommends copying
your running-configuration to the startup-configuration. The system uses the startup-configuration during
boot-up to configure the system. The startup-configuration is stored in the internal flash on the IOM by
default, but you can save the startup-configuration to a USB flash device or on a remote server.
To save the running-configuration:
Task
Save re-configured settings to the
startup configuration.
Note: The following commands are the same format as those in
page 31 but use the filenames startup-config and running-config. These commands assume that current
directory is the internal flash, which is the system default.
Task
Save the running-configuration to:
the startup-configuration on the
internal flash
the usb flash on the IOM
an FTP server
a TFTP server
Remote Location
Command Syntax
write memory
Command Syntax
copy running-config startup-config
copy running-config usbflash://filename
copy running-config ftp://
username:password@{hostip
filename
copy running-config tftp://{hostip
filename
command to import a file to the Dell Force10 system from
copy
Local Location
Copy Files to and from the System on
| hostname}/filepath/
|
hostname}/filepath/
Command Mode
CONFIGURATION
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
EXEC Privilege
Getting Started | 33